Nad C 320BEE User Manual download pdf (Page 9)

ENGLISH

FRANÇAISDEUTSCHNEDERLANDSESPAÑOL

ITALIANO

PORTUGUÊS

SVENSKA

PROBLEM CAUSE SOLUTION

NO SOUND

• Power AC lead unplugged or power not

switched on

• Check if AC lead is plugged in and power

switched on

• Tape 1 Monitor selected • De-select Tape 1 Monitor mode

• Mute on • Switch off Mute

• Rear Pre-out/Main-in amp links not fitted • Fit links

• Headphones inserted • Disconnect headphones

NO SOUND ONE CHANNEL

• Balance control not centered • Center Balance control

• Speaker not properly connected or damaged • Check connections and speakers

• Input lead disconnected or damaged • Check leads and connections

WEAK BASS / DIFFUSE STEREO IMAGE

• Speakers wired out of phase • Check connections to all speakers in the system

REMOTE CONTROL HANDSET

NOT WORKING

• Batteries flat, or incorrectly inserted • Check or replace batteries

• IR transmitter or receiver windows obstructed • Remove obstruction

• IR receiver in direct sun or very bright ambient

light

• Place unit away from direct sun, reduce amount

of ambient light

POWER/PROTECTION LED TURNS RED

DURING OPERATION

• Amplifier has overheated • Turn amplifier off, make sure ventilation slots on

top and bottom of amplifier are not blocked.

After amplifier has cooled down, turn back on

• Overall impedance of loudspeakers too low • Ensure the overall loudspeaker impedance is not

below 4 ohms

TROUBLESHOOTING

PRESS IN AND LIFT TAB TO REMOVE

BATTERY COVER OUT FROM RECESS

PLACE BATTERIES INTO OPENING. ENSURE

THE CORRECT POLARITY IS OBSERVED

REPLACE BATTERY COVER BY ALIGNING AND

INSERTING THE TWO TABS INTO THE HOLES.

PRESS BATTERY COVER INTO PLACE UNTIL IT

'CLICKS' CLOSED

C320BEE_v02.qxd 6/16/2005 5:17 PM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 77 78

Comments to this Manuals

No comments

Nad C 320BEE User Manual Page 9

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Nad C 320BEE