NAD C 326BEE Owner's Manual

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ®Owner’s ManualC 326BEEStereo Integrated Amplier

USING THE SR 8 REMOTE CONTROLThe SR 8 remote control handset handles the key functions of the C 326BEE as well as other NAD Stereo Receivers, Integrat

8 VOL [ ]: Press [ ] button to increase or decrease the loudness level. Release the button when the desired level is reached. For NAD Receivers,

USING THE SR 8 REMOTE CONTROL LIBRARYThe SR 8 can store a dierent library of default NAD codes for each of its DEVICE SELECTOR “pages.” If the origin

CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONSNo sound. • Power AC lead unplugged or power not switched ON.• Check if AC lead is plugged in and power

PREAMPLIFIER SECTIONLINE LEVEL INPUT, PRE OUT THD (2 Vin 2 Vout, CCIF IMD, DIM 100) >0.004 % (ref. 20 Hz – 20 kHz) Signal/Noise ratio IHF >

OVERALL SPECIFICATIONSCD IN, SPEAKER OUT THD (250 mW to rated power, CCIF IMD, DIM 100) <0.009 % (ref. 20 Hz - 20 kHz) Signal/Noise ratio >

www.NADelectronics.com©2009 NAD ELECTRONICS INTERNATIONALA DIVISION OF LENBROOK INDUSTRIES LIMITEDAll rights reserved. No part of this publication may

SAVE THESE INSTRUCTIONS FOR LATER USE.FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO EQUIPMENT.1 Read instructions - All the safety and ope

19 Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to qualied service personnel under the following conditio

NOTES ON ENVIRONMENTAL PROTECTIONAt the end of its useful life, this product must not be disposed of with regular household waste but must be returned

INTRODUCTIONGETTING STARTEDUNPACKING AND SETUPWHAT’S IN THE BOXPacked with your C 326BEE you will nd:• The SR 8 remote control with 2 (two) AA batte

IDENTIFICATION OF CONTROLSFRONT PANEL1 STANDBY: With the rear panel POWER switch set to ON position, press this button to switch ON the C 326BEE fro

7 INPUT SELECTORS: These buttons select the active input to the NAD C 326BEE and the signal sent to the loudspeakers, headphones and the PRE OUT sock

1 MP INPUT: Input for a Media Player or other line-level signal source. Use a twin RCA-to-RCA lead to connect the Media Player’s left and right “Audi

10 MAIN IN: Connections to an external pre-amplier or processor, such as a surround-sound decoder. In normal use, this should be connected to PRE OU